F.USED Indication
Displays fuel used as computed by the FADEC. The value is frozen at engine shutdown and is reset at engine start on the ground. The last two digits are dshed if the fuel used indication is inaccurate due to loss of fuel flow for more than one minute.

OIL Quantity Indication
Displays Oil Quantity inquarts. Represented by pointer and digital display. Indication pulses below 5 quarts (decreasing) or 7 quarts (increasing).

OIL Pressure Indication
Represented by pointer and digital display. The digital indication pulses if oil pressure exceeds 390 psi (increasing) or 385 (decreasing). Both indications become amber below 80 psi and red below 60 psi.

OIL Temperature Indication
Displays Oil Temperature in °C. The indication pulses above 156°C (increasing) or 150°C (decreasing). It becomes amber if the temperature exceeds 156°C for more than 15 minutes or instantaneously when above 165°C.

IGN Indication
Displays during start sequence. The selected Ignitors "A" or "B" or "AB" are displayed when supplied.

Engine Bleed Pressure
Displays Bleed Pressure upstream from the precooler. The value becomes amber below 21 psi when N₂ exceeds 10% with the engine start valve not closed or when Bleed over-pressure is detected.

VIB Indications
Displays N₁ and N₂ Vibration levels. The indication pulses above 5.0. The data is also displayed on the ECAM cruise page.

OIL Filter Indication
Displays Filter status. An amber CLOG massage appears in case of excessive pressure loss across the main oil scavenge.

F.Filter Indication
Displays fuel Filter status. An amber CLOG massage appears in case of excessive pressure loss across the fuel filter.

TAT, SAT & GW
Message Area

Start Valve Indication
Displays positive of start valve. A horizontal line through the circle signifies the valve is fully open. A vertical line signifies the valve is fully closed.